Get exactly the support you need
Looking for specific solutions for your product?

My Philips Steam Generator Iron does not produce any steam

If your Philips Steam Generator Iron stopped producing steam, please read our troubleshooting advice below to solve this.

There is no water in the water tank

If the water level on your Philips Steam Generator Iron is below the minimum level or there is no water in the tank, your iron is not able to generate steam. Please refill the water tank with water. Ensure that there is water in the tank or the water is above the MIN level icon. After this, your iron should work again.

The iron is not ready to steam

Your Philips Steam Generator Iron needs up to 2 minutes for heating up, before it is ready to produce steam. 
Please wait until the blue 'iron ready' light stops flashing and lights up continuously.

The steam trigger is not pressed

You need to press the steam trigger to generate steam. If you have a Philips Steam Generator Iron with OptimalTemp, always press the steam button to generate steam.  

Note: If you have a Philips Steam Generator Iron with a temperature dial, always make sure that the temperature dial is at the 2-dot, 3-dot or the LINEN position as shown in the image below. Your Philips Iron does not produce steam when the temperature dial is at the 1-dot position, the SYNTH setting or in Calc-Clean.

The iron needs to be descaled

The iron is used for the first time

When you press your iron’s steam trigger for the first time, you will experience a steam delay of 30 seconds.  During these 30 seconds, you will hear a pumping sound. Thereafter press the steam trigger again to produce steam. 

Note: The 30 seconds steam delay could take up to a few minutes when the iron was stored for a long time.

Note: Do not forget to fill in the water tank with water before pressing the steam button for the first time. 

Intelligent automatic steam mode or Speed mode is off

If you prefer to use the automatic steam mode or speed mode, ensure that the automatic steam button or Speed mode button on top of the handle is pressed as show in the image below, and thereafter move your Philips Steam Generator Iron to have steam.

Did these solutions above not solve the issue? Please contact us for further assistance.

Our site can best be viewed with the latest version of Microsoft Edge, Google Chrome or Firefox.