How to flush my Philips AquaTrio Pro after use

Start with switching off your Philips AquaTrio Pro. Place the appliance upright in parking position and pull the plug out of the wall socket.

After emptying the dirty water in the water tank of the device, fill the clean water tank with water.

Note:

Make sure the clean water tank is filled and the dirty water tank is empty before you start flushing the appliance to prevent interruption of the flushing process. Interruption of the process has a negative effect on the flushing result.

Use a measuring cup and fill it with 300ml of water. In the meanwhile, place the appliance on the flushing tray.

Note:

If you wish, you can add some liquid floor cleaner to the water.

Pour the water you filled in a measuring cup slowly into the flushing tray. Make sure the water level does not exceed the MAX indication.

After putting the mains plug in the wall socket, switch on the appliance.

Once you let the appliance operate, wait until the water in the flushing tray is used up. This takes approximately 15 seconds.

Once the water in the flushing tray is used up, switch off your Philips AquaTrio Pro and unplug it.

After flushing, open the mopping nozzle lid of your Philips AquaTrio Pro, remove the mopping brush cover and check if the inside is clean. Do not forget to rinse the flushing tray under running water after flushing.

Note:

If you have flushed the appliance and it remains dirty, you can clean each part separately.