Consumer
Products

PhotoFrame

25.9 cm/10.2" LCD, 16:9 frame ratio 10FF3CME/00

Troubleshooting

How to update the firmware of my Philips photoframe?

You can download the latest firmware from the software & drivers section. To update the frame you will require an SD card.

Upgrade Instructions

1) Download the latest firmware to your PC from the software & drivers section

2) Locate the file on your hard-drive and extract it; this can be done by right-clicking the zip folder on most PCs

3) Open the new, non-zipped, folder and copy the contents onto your SD card- This should be copied into the root directory of the card i.e. it should not be within a folder

4) Turn off the photo frame

5) Insert the SD card into the SD card slot at the rear of the photo frame; this should be marked ‘SD’

6) Turn on the photo frame

7) The firmware update should start automatically

Note: If there is more than 1 SD card slot on your photo frame it is not important which one is used

The information on this page applies to the following models: 10FF3CME/00 , 8FF3CDW/00 , 8FF3CME/00 .

Not what you are looking for?